Agilent Technologies 35670A User Manual

Agilent 35670A Rear Panel
1-The GPIB connector links the Agilent 35670A
to other GPIB devices. GPIB parameters are set in
the [
Local/GPIB
] and [
Plot/Print
] menus.
2-The SERIAL PORT and the PARALLEL
PORT link the analyzer to plotters and printers.
These parameters are set in the [
Plot/Print
] menu.
3-The SOURCE connector outputs the analyzer’s
source signal. An LED on the front panel
indicates if the source is on or off. The source
parameters are set in the [
Source
] menu.
The standard Agilent 35670A (2-channel) also has
a source connector on the front panel.
4-The EXT TRIG connector links the analyzer to
an external trigger signal. The external trigger
parameters are set in the [
Trigger
] menu.
5-The TACH connector links the analyzer to a
tachometer. The tachometer parameters are set in
the [
Input
] menu.
6-The KEYBOARD connector attaches an
optional keyboard to the analyzer.
7-The DC POWER connector accepts DC power
levels from 12 - 28 Vdc (nominal).
8-The AC POWER connector accept a wide range
of ac voltage levels.
9-The POWER SELECT switch determines
whether the analyzer is powered via the AC
POWER connector or the DC POWER connector.
10-The EXT MONITOR port links the analyzer
to multi-sync monitors.

Agilent Technologies 35670A Specifications

General

Brand	Agilent Technologies
Model	35670A
Category	Measuring Instruments
Language	English