Agilent Technologies 8960 Series - Page 370

370
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_call_schannel.fm
CALL:SCHannel
CALL:SCHannel:DRATe:RCONfig5
CALL:SCHannel:ENCoder
Function Sets/queries the data rate of the radio configuration 5 (RC5) forward supplemental channel
(SCH) in bits per second.
Setting Range: BPS14400|BPS28800|BPS57600|BPS115200|BPS230400
Query Range: BPS14400|BPS28800|BPS57600|BPS115200|BPS230400
*RST Setting BPS14400
Programming Example
OUTPUT 714;"CALL:SCHANNEL:DRATE:RCONFIG5 BPS57600"
Function Sets/queries which encoder is used for the supplemental data.
If the SCH data rate has been set to the base rate for the current radio configuration (base rates
are data rates below 19.2 kbps), the convolutional encoder is used regardless of this parameter
setting.
The current radio configuration is selected by the “CALL[:CELL]:RCONfig” command.
Setting Range: TURBo|CONVolution
Query Range: TURB|CONV
*RST Setting CONVolution
Programming Example
OUTPUT 714;"CALL:SCHANNEL:ENCODER TURBO" !Sets the SCH encoder to turbo mode.