To Next Page

To Previous Page

469

S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_fetch_wquality.fm

FETCh:WQUality

FETCh:WQUality:ICOunt?

FETCh:WQUality:CDPower:IQINactive[:FAIL]?

FETCh:WQUality:CDPower:ICHannel[:ALL]?

Function Queries the intermediate count of measurements completed in a multi-measurement.

Query Range: 0 to 999

Programming Example

OUTPUT 714;"FETCH:WQUALITY:ICOUNT?"

Function Queries the code domain measurement’s pass/fail result indicating whether the

power level in the inactive code channels exceeded the level set using the

“SETup:WQUality:CDPower:IQINactive[:LIMit]” command.

Query Range: 0|1, 9.91 E+37

0 = passed, 1 = failed, 9.91 E+37 = undefined

Programming Example

OUTPUT 714;"FETCH:WQUALITY:CDPOWER:IQINACTIVE:FAIL?"

Function Queries the I-channel code domain power measurement results for all 16 measurement graph

bars (bins).

This query returns a string consisting of 64 comma-separated values. These represent 4 values

for each of 16 bins (maximum).

Since measurements will usually have less than 16 bins, higher numbered bins frequently return

9.91 E+37 results.

Query “FETCh:WQUality:CDPower:ICHannel:ALL?” returns: 1 (active) or 0 (inactive), Walsh code,

spread factor, and power for bin 0. The integer value following power for bin 0 will be the

beginning of bin 1; 1 (active) or 0 (inactive), Walsh code, spread factor, and power for bin 1. This

pattern will repeat until the values for the last bin (bin 15) have been returned.

Programming Example

OUTPUT 714;"FETCH:WQUALITY:CDPOWER:ICHANNEL:ALL?"

Agilent Technologies 8960 Series Reference Guide

Other manuals for Agilent Technologies 8960 Series