Agilent Technologies 8960 Series

541
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_setup_fm.fm
SETup:FM
“Diagram Conventions” on page 248
SETup:FM:CONTinuous
Function Sets/queries the trigger arm state for the FM measurement. Determines whether measurement
will make one measurement then stop (0|OFF (single)), or automatically rearm upon completion
of one measurement and repeat the process (1|ON (continuous)).
Setting Range: 1|ON|0|OFF
Query Range: 1|0
*RST Setting 0 (off)
Programming Example
OUTPUT 714;"SETUP:FM:CONTINUOUS ON”
!Sets measurement to continuous trigger mode.
SETup :FM :FILTer <sp><num value>[HZ|
KHZ|MHZ|GHZ
[:TYPE]
(returns NONE|TBP|CMES|BPAS50|
[:FREQuency]
<sp>NONE|TBPass|CMESsage|BPASs50|
:TBPass
? (returns num value)
BPASs300
BPAS300)
?
:FREQuency
:STATe
<sp>1|ON|0|OFF
? (returns1|0)
SETup :FM
:TIMeout
[:STIMe]
? (returns num value)
:TIME
? (returns num value)
:STATe
<sp>1|ON|0|OFF
Complex Command
? (returns1|0)
<sp><num value>[S|MS|US|NS]
<sp><num value>[S|MS|US|NS]