547
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_setup_fstability.fm
SETup:FSTability
SETup:FSTability:CONTinuous
SETup:FSTability:COUNt[:SNUMber]
SETup:FSTability:COUNt:NUMBer
Function Sets/queries the trigger arm state for the frequency stability measurement. Determines whether
measurement will make one measurement then stop (0|OFF (single)), or automatically rearm
upon completion of one measurement and repeat the process (1|ON (continuous)).
Setting Range: 1|ON|0|OFF
Query Range: 1|0
*RST Setting 0 (off)
Programming Example
OUTPUT 714;"SETUP:FSTABILITY:CONTINUOUS ON”
!Sets measurement to continuous trigger mode.
Function Sets/queries the number of frequency stability measurements to be made in a
multi-measurement setup. This command sets the count, and automatically sets the
multi-measurement STATe command to 1 (on).
Setting Range: 1 to 999
Query Range: 1 to 999
*RST Setting 10, on
Programming Example
OUTPUT 714;"SETUP:FSTABILITY:COUNT:SNUMBER 5”
!Turns on multi-measurements and sets the number of measurements to 5.
Function Sets/queries the number of frequency stability measurements to be made when
multi-measurement state is ON.
Setting Range: 1 to 999
Query Range: 1 to 999
*RST Setting 10
Programming Example
OUTPUT 714;"SETUP:FSTABILITY:COUNT:NUMBER 5”
!Sets the number of measurements to 5 when the multi-measurement state is set to ON.
To Next Page
Loading...
Need help?
General
