Agilent Technologies 8960 Series

590
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_status_operation.fm
STATus:OPERation:
Program Examples - STATus:OPERation:NMRReady:CDMA
OUTPUT 714;"STATUS:OPERATION:NMRREADY:CDMA:EVENT?" !Queries the New Measurement
!Results Ready CDMA Event Register.
OUTPUT 714;"STATUS:OPERATION:NMRREADY:CDMA:CONDITION?" !Queries the New Measurement
!Results Ready CDMA
!Condition Register.
OUTPUT 714;"STATUS:OPERATION:NMRREADY:CDMA:ENABLE 8" !Sets New Measurement Results
!Ready CDMA Enable Regigter
!for bit 3.
OUTPUT 714;"STATUS:OPERATION:NMRREADY:CDMA:NTR 2" !Sets the New Measurement Results
!Ready CDMA Negative Transition
!Register for bit 1.
OUTPUT 714;"STATUS:OPERATION:NMRREADY:CDMA:PTR 4" !Sets the New Measurement
!Results Ready CDMA Positive
!Transition Register
!for bit 2
3 8 CPOWer New Measurement
Result Ready
This bit is a 1 if the measurement has been
completed and has produced new results.
This bit is a zero at power on, after a preset and
while a measurement is in Measuring States. See
“Triggering of Measurements” on page 218.
2 4 WQUality New Measurement
Result Ready
This bit is a 1 if the measurement has been
completed and has produced new results.
This bit is a zero at power on, after a preset and
while a measurement is in Measuring States. See
“Triggering of Measurements” on page 218.
1 2 DAPower New Measurement
Result Ready
This bit is a 1 if the measurement has been
completed and has produced new results.
This bit is a zero at power on, after a preset and
while a measurement is in Measuring States. See
“Triggering of Measurements” on page 218.
0 1 Extension Bit This bit is always 0.
Bit
Number
Binary
Weighting
Condition Description