Agilent Technologies 8960 Series

593
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_status_operation.fm
STATus:OPERation:
STATus:OPERation:NMRReady:DIGital2000 Register Bit Assignments
The STATus:OPERation:NMRReady:DIGital2000 register bits indicate when a measurement has been
completed and new measurement results are available.
Bit
Number
Binary
Weighting
Condition Description
15 32768 Not Used. Defined by SCPI. This bit is always 0.
14 16384 Reserved for future use. This bit is always 0.
13 8192 Reserved for future use. This bit is always 0.
12 4096 Reserved for future use. This bit is always 0.
11 2048 Reserved for future use. This bit is always 0.
10 1024 Reserved for future use. This bit is always 0.
9 512 Reserved for future use. This bit is always 0.
8 256 Reserved for future use. This bit is always 0.
7 128 Reserved for future use. This bit is always 0.
6 64 Reserved for future use. This bit is always 0.
5 32 Reserved for future use. This bit is always 0.
4 16 Reserved for future use. This bit is always 0.
3 8 TFERror New Measurement Result Ready. This bit is a 1 if the measurement has been
completed and has produced new results.
This bit is a zero at power on, after a preset
and while a measurement is in Measuring
States. See “Triggering of Measurements” on
page 218.
2 4 CCTPhase New Measurement Result Ready. This bit is a 1 if the measurement has been
completed and has produced new results.
This bit is a zero at power on, after a preset
and while a measurement is in Measuring
States. See “Triggering of Measurements” on
page 218.
1 2 HWQuality New Measurement Result
Ready.
This bit is a 1 if the measurement has been
completed and has produced new results.
This bit is a zero at power on, after a preset
and while a measurement is in Measuring
States. See “Triggering of Measurements” on
page 218.