698
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_gen_print_screen.fm
Printing Screens
Restart Windows
Depending on your LAN network adapter, your computer may or may not apply the network configuration
changes as they are made. It is import that you restart Windows NOW to make sure new LAN settings are in
effect when you try to connect to the test set.
Changing the LAN Settings on Your Test Set 1.Press the
SYSTEM CONFIG key on the test set to display
the current LAN settings.
2. Press the
F1 (Instrument Setup) key.
NOTE Changing the LAN IP Address may alter the Subnet Mask setting. Therefore, change the LAN IP
Address first, then change the Subnet Mask. Also, The last entry in the IP Address must not be
>254 or 0.
3. Turn the knob to highlight the setting you want to change.
4. Press the knob to select the setting.
5. Enter the new value using the keypad, and press the knob to complete the setting.
6. Turn the test set off and back on to start using the new settings.
To Next Page
Loading...
Need help?
General
