739
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_ts_err_msg_pos200.fm
+200 through +299 Error Message Descriptions
+200 through +299 Error Message Descriptions
Description
A device-specific error indicates that the instrument has detected an error that occurred because some
operations did not properly complete, possibly due to an abnormal hardware or firmware condition. For
example, an attempt by the user to set an out of range value will generate a device specific error. Errors are
categorized as follows:
• TA2000: errors with test application scope
• CDMA: errors common to the IS-95 and IS-2000 System Types
• Digital2000: errors applicable to only the IS-2000 System Type
• Digital95: errors applicable to only the IS-95 System Type
When one of these errors is generated, the +200 errors bit in the questionable error status register is set.
Table 17. TA2000 Call Processing Errors
Error Message Description
+271 Release order not received
+272 Handoff completion not received
+273 Carrier not detected on new channel
+274 MS reject order received <reason>
+275 Unexpected message received and ignored
Table 18. CDMA Call Processing Errors
Error Message Description
+270 Traffic channel preamble not received
+271 MS ack of initial BS ack order not received
+272 MS ack order not received
+273 Service Option or Radio Configuration rejected by MS
+274 Service response not received
+275 Service request not received
+276 Service connect completion not received
+277 Call drop timer timed out
+278 Status response not received
+279 Walsh code cannot be changed while a call is connected
To Next Page
Loading...
Need help?
General
