761
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_conf_hw_report.fm
Hardware Configuration Report
Hardware Configuration Report
Description
You can generate a list of the test set’s hardware configuration over the LAN or GPIB.
The LAN query is the easiest and most direct way to query the test set’s hardware configuration. This method
uses your web browser to display a formatted report.
The GPIB query returns an unformatted character string that must be buffered and saved to an HTML file to
provide formatted text.
LAN Query
1. Refer to the SYSTEM CONFIG screen to determine the LAN address.
2. Open a web browser and enter <LAN address>/iconfig. For example, if your LAN address is 130.2.2.147,
you would enter:
130.2.2.147/iconfig
3. The web browser will then display formatted text. A partial list of the hardware configuration information
is shown below:
GPIB Query
Use the following Basic example as a model to store the test set’s configuration as an HTML file.
GPIB Example:
10 DIM Buf1$[20000],Buf2$[20000] ! This is the minimum space for the arrays
20 OUTPUT 714;”SYSTEM:CONFIGURE:INFORMATION:HARDWARE:VERBOSE?”
30 ENTER 714;Buf1$,Buf2$
40 CREATE “HW.htm”,1 ! Create an HTML file
50 ASSIGN @File TO “HW.htm”
60 OUTPUT @File;Buf1$,Buf2$
70 END
To Next Page
Loading...
Need help?
General
