276 Chapter 6
Data Analysis
Performing Parameter Conversion of Measurement Results
Selecting Conversion Target Parameter
Step 1. Press or to activate the channel on which you want to use the
marker.
Step 2. Press or to activate the trace on which you want to use the marker.
Step 3. Press .
Step 4. Press Conversion.
Step 5. Press Function.
Step 6. Press the softkey corresponding to the parameter to which you want to convert the result.
When the conversion function is ON, the selected parameter is displayed in “5-5. Trace
Status Area” on page 48.
To Next Page
Loading...
