Agilent Technologies ENA Series

Appendix C 635
List of Default Values
List of Default Values, Save/Recall Settings, and Backup Settings
C. List of Default Values
Sweep Time AUTO ← ← √ K/C
Sweep Delay 0.0000 s ← ← √ K/C
Sweep Mode Std Stepped ← ← √ K/C
Points 201 ← ← √ K/C
Sweep Type Linear ← ← √ K/C
Edit Segment Table
Freq Mode Start/Stop ← ← √ K/C
List IFBW OFF ← ← √ K/C
List Power OFF ← ← √ K/C
List Delay OFF ← ← √ K/C
List Sweep Mode OFF ← ← √ K/C
List Time OFF ← ← √ K/C
Segment Display Order Base ← ← √ K/C
Frequency Offset
Frequency Offset OFF ← ← √ K/C
Port 1
Multiplier 1.0000 ← ← √ K/C
Divisor 1.0000 ← ← √ K/C
Offset 0.0000 Hz ← ← √ K/C
Start 300.00 kHz ← ← √ K/C
Stop 8.5000 GHz ← ← √ K/C
Port 2
Multiplier 1.0000 ← ← √ K/C
Divisor 1.0000 ← ← √ K/C
Offset 0.0000 Hz ← ← √ K/C
Start 300.00 kHz ← ← √ K/C
Stop 8.5000 GHz ← ← √ K/C
Port 3
Multiplier 1.0000 ← ← √ K/C
Divisor 1.0000 ← ← √ K/C
Offset 0.0000 Hz ← ← √ K/C
Start 300.00 kHz ← ← √ K/C
Stop 8.5000 GHz ← ← √ K/C
Port 4
Multiplier 1.0000 ← ← √ K/C
Divisor 1.0000 ← ← √ K/C
Offset 0.0000 Hz ← ← √ K/C
Start 300.00 kHz ← ← √ K/C
Stop 8.5000 GHz ← ← √ K/C
Key Operation Factory-shipped Setting Default Value Save/
Recall
Backup Available
Means of
Defining a
Setting
*RST