Ashida ADR233B - Page 19

ADR233B
Doc ID : ADR233B/IM/01
Ref ID : ADR233B/IM/ToC
Rev No. : 05
Page No. : 19 of 479
8.4.11.7.4 Residual OC (If Definite Time is selected) 353
8.4.11.8 Sequence OC 356
8.4.11.8.1 W1 Sequence OC (If Disabled) 356
8.4.11.8.2 Sequence OC (If IEC Curve is selected) 358
8.4.11.8.3 Sequence OC (If IEEE / US Curve is selected) 361
8.4.11.8.4 Sequence OC (If Definite Time is selected) 364
8.4.11.9 Under Voltage 367
8.4.11.9.1 To Set – Under Voltage (If Disabled) 367
8.4.11.9.2 To Set – Under Voltage (If Enabled) 368
8.4.11.10 Over Voltage 369
8.4.11.10.1 To Set – Over Voltage (If Disabled) 369
8.4.11.10.2 To Set – Over Voltage (If Enable) 370
8.4.11.11 V/Hz Protection 372
8.4.11.11.1 V/Hz Protection (If Disabled) 372
8.4.11.11.2 V/Hz Protection (If Enabled) 373
8.4.11.12 Breaker Failure 375
8.4.11.12.1 To Set – W1 50BF (If Disabled) 375
8.4.11.12.2 To Set – W1 50 BF (If Enabled) 376
8.4.11.13 Thermal Overload 378
8.4.11.13.1 To Set – Thermal Overload (If Disabled) 378
8.4.11.13.2 To Set – Thermal Overload (If Enabled) 379
8.4.11.14 Through Fault 381
8.4.11.14.1 Through Fault (If Disabled) 381
8.4.11.14.2 Through Fault (If Enabled) 382
8.4.12 Active Group 383
8.4.12.1 To View – Active Group 383
Section 9 : FLOW CHART
Sr. No. Description Page No.
9 Flow Chart Overview 388
9.1 Main Menu 388
9.2 EDIT and SAVE settings 389
9.3 Measurement 390
9.3.1 To View – Measurement 1 390
9.3.2 To View – Measurement 2 392