Ashida ADR233B - Page 307

Doc ID :ADR233B/IM/01
Ref ID : ADR233B/IM/UG
Rev No. : 05
Page No. : 307 of 479
ADR233B
REF
Editable Setting
By using the Plus / Up arrow key (+ /) or the Minus / Down
arrow key (- /) select REF.
Password protected window for “REF” setting i.e. REF
Enable Disabled/HighZ/LowZ, (If LowZ: Ref. Winding, Isr>1,
Isr>2, Slope1, Slope2, tIsr>) and (If HighZ: Isr>), 2nd Hrm
REF BLK (2nd Hrm Threshold.)
Press the Minus / Down arrow key (- /) to move to the next
option.
Phase OC
Editable Setting
By using the Plus / Up arrow key (+ /) or the Minus / Down
arrow key (- /) select Phase OC.
Password protected window for “Phase OC” setting i.e. W1
Phase OC (IP>1 Enable, IP>2 Enable and IP>3 Enable) and
W2 Phase OC (IP>1 Enable, IP>2 Enable and IP>3 Enable)
can be set as Disabled / Enabled
Press the Minus / Down arrow key (- /) to move to the next
option.
Ground OC
Editable Setting
By using the Plus / Up arrow key (+ /) or the Minus / Down
arrow key (- /) select Ground OC.
Password protected window for “Ground OC” setting i.e.
REF GROUND OC (IE>1 Enable, IE>2 Enable and IE>3
Enable) can be set as Disabled / Enabled
Press the Minus / Down arrow key (- /) to move to the next
option.
Residual OC
Editable Setting
By using the Plus / Up arrow key (+ /) or the Minus / Down
arrow key (- /) select Residual OC.
Password protected window for “Residual OC” setting i.e.
W1 Residual OC (3Io>1 Enable, 3Io>2 Enable and 3Io>3
Enable) and W2 Residual OC (3Io>1 Enable, 3Io>2 Enable
and 3Io>3 Enable) can be set as Disabled / Enabled
Press the Minus / Down arrow key (- /) to move to the next
option.