Maintenance-Object Repair Procedures
555-233-143
8-752 Issue 1 May 2002
Session Status Test (#1286)
This nondestructive test determines the status of every Ethernet port session.
This test queries the system software on port session status.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
2. Escalate if the problem persists.
FAIL Link integrity lost due to problem with attachment of Ethernet cable to the port.
1. Repeat the test.
2. If the test fails, verify that the cable properly is secured to Ethernet port and
to the bus.
3. Verify the C-LAN circuit pack’s link integrity LED is glowing.
4. Retry the test.
5. If problem persists, see Ethernet Local Loop-around test (#1278) repair
procedures.
PASS The Ethernet Link Integrity test (#1282) detects good connections.
If the system software indicates that: Then the switch:
Every port session is up (ALL UP) Raises no alarm, or retires alarm
Some port sessions are up (SOME UP) Raises WARNING alarm
Every port session is down (ALL DOWN) Raises MINOR alarm
Table 8-294. Test #1282 Link Integrity Inquiry Test — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page
To Next Page
Loading...
