Avaya S8700 - Page 2187

SNI-BD (SNI Circuit Pack)
Issue 1 May 2002
8-1465555-233-143
114 FAIL The SNI circuit pack cannot communicate with the equipped SNI in slot 14.
1. Perform the Fiber Fault Isolation Procedure described in Chapter 5. This
will resolve multiple SNI-PEER errors.
2. If the SNI being tested has SNI-PEER error type 2305, replace the SNI
being tested. Replacing an SNI may be service interrupting. See
‘‘SNC-BD (Switch Node Clock Circuit Pack)’’ on page 8-1384 for the
procedure for replacing an SNI. To view SNI-PEER errors, use the display
errors command with category PNC-PEER. Retry the command.
3. If the SNI being tested has SNI-PEER error type 2305, replace the SNI in
slot 14. Replacing an SNI may be service interrupting. See ‘‘SNI-BD (SNI
Circuit Pack)’’ on page 8-1429 for the procedure for replacing an SNI.
Retry the command.
115 FAIL The SNI circuit pack cannot communicate with the equipped SNI in slot 15.
1. Perform the Fiber Fault Isolation Procedure described in Chapter 5. This
will resolve multiple SNI-PEER errors.
2. If the SNI being tested has SNI-PEER error type 2561, replace the SNI
being tested. Replacing an SNI may be service interrupting. See ‘‘SNI-BD
(SNI Circuit Pack)’’ on page 8-1429 for the procedure for replacing an SNI.
To view SNI-PEER errors, use the display errors command with category
PNC-PEER. Retry the command.
3. If the SNI being tested has SNI-PEER error type 2561, replace the SNI in
slot 15. Replacing an SNI may be service interrupting. See ‘‘SNI-BD (SNI
Circuit Pack)’’ on page 8-1429 for the procedure for replacing an SNI.
Retry the command.
116 FAIL The SNI circuit pack cannot communicate with the equipped SNI in slot 16.
1. Perform the Fiber Fault Isolation Procedure described in Chapter 5. This
will resolve multiple SNI-PEER errors.
2. If the SNI being tested has SNI-PEER error type 2817, replace the SNI
being tested. Replacing an SNI may be service interrupting. See ‘‘SNI-BD
(SNI Circuit Pack)’’ on page 8-1429 for the procedure for replacing an SNI.
To view SNI-PEER errors, use the display errors command with category
PNC-PEER. Retry the command.
3. If the SNI being tested has SNI-PEER error type 2817, replace the SNI in
slot 16. Replacing an SNI may be service interrupting. See ‘‘SNI-BD (SNI
Circuit Pack)’’ on page 8-1429 for the procedure for replacing an SNI.
Retry the command.
Table 8-579. TEST #759 Configuration Audit — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page