Avaya S8700 - Page 552

Maintenance Commands
555-233-143
7-296 Issue 1 May 2002
Interpreting Results of the status bri-port
Command
Table 7-45 will help to interpret results of the status bri-port command. Find the
combination of output field values contained in your report and follow the
recommendations for the type of endpoint connected to the portStatus Cabinet
status cabinet UU [print]
This command displays the operational status and attributes of the specified
cabinet. The output screen displays configuration information for each carrier,
connectivity and alarm information for each port network or switch node, and the
emergency transfer status of the cabinet.
The cabinet number defaults to 1.
Table 7-45. Interpreting BRI-Port Status Reports
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
ASAI,
BRI
0-126 Assigned blank blank This is a transitory state for BRI
endpoints and ASAI adjuncts. The
switch is attempting to establish the
link.
1. Check the endpoint and wiring
by following the SPID Facility
test’s procedure described in
the BRI-SET section of Chapter
8.
2. Repeat status bri-port to
determine that the Layer 2 state
of the signaling link is either
L3-Established (for ASAI
adjuncts and BRI endpoints
supporting MIM initialization) or
Established (for fixed TEI
BRI endpoints and automatic
TEI BRI endpoints not
supporting MIM initialization). If
it is not, follow normal
escalation procedures. (A MIM
or management information
message is a level-3 message
that conveys management and
maintenance information
between a communications
system and a BRI terminal.)
Continued on next page