EasyManua.ls Logo

Avaya S8700 - Page 898

Avaya S8700
2618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance-Object Repair Procedures
555-233-143
8-176 Issue 1 May 2002
Service State Audit Test (#256)
This test checks the service state of the trunk.
Country protocol 1. If the interface uses country protocol 1 (includes USA), the
service-state audit executes in every trunk service state. It queries the service
state on the far end and waits 2 minutes for a reply. If the first request times out,
the service-state audit asks again. If the request times out again, it logs error
3073 and resends the request every 15 minutes. It places in-service trunks in the
MAINTENANCE/FAR-END state (outgoing calls blocked, incoming calls
accepted). Incoming calls trigger an immediate service-state audit without waiting
for the end of a 15-minute cycle.
Any other country protocol. If the interface uses some other country protocol, the
service-state audit executes only on trunks that are in the
OUT-OF-SERVICE/FAR-END state. It asks the far-end switch to bring the trunk
back into the IN-SERVICE state and waits 2 minutes for a reply. If the first request
times out, the service-state audit asks again. If the request times out again, it
leaves the trunk in the OUT-OF-SERVICE/FAR-END state and tries again in 1
hour.
NOTE:
PASS for this test only means that a message to the far end was
successfully sent.
To check the service state of the ATM-BCH trunk, run status trunk grp#/mbr#.
Table 8-72. Test #256 Service State Audit Test
Error
Code
Tes t
Result Description / Recommendation
1000 ABORT Needed resources not available, port on a call or initializing
1. Run status trunk grp#/mbr#.
1. Check the results of Test #255.
1018 ABORT Maintenance disabled
1. Enable maintenance by entering y in the
Maintenance Tests? field
on page 2 of the change trunk-group form.
1113 ABORT Signaling link failed
1. Run status trunk grp#/mbr#.
2. Check the results of Test #255.
3. See the ‘‘ATM-SGRP (ATM Signaling Group)’’ MO.
1114 ABORT Signaling link in transitional state
1. Retry the command up to 5 times at 1-minute intervals.
Continued on next page

Table of Contents

Other manuals for Avaya S8700

Related product manuals