ATM-EI (Expansion Interface Circuit Pack)
Issue 1 May 2002
8-215555-233-143
0NO
BOARD
No board was detected by the test.
1. Check the Error Log for wrong board (Error Type 125) or no board (Error
Type 131). Resolve either of these issues, if applicable.
2. Check that the board is properly translated and inserted. If so, check for
hyperactivity (Error Type 1538). If hyperactive, use the reset board
UUCSS command.
3. Run the test again. If it fails, the NCE chip on board could be bad.
Replace the board and retest.
Table 8-90. XXYY Error Codes for Test #1259
(ATM Board Error Query Test)
XX Aux Data Description
1 ATM framer chip failed
2 NCE chip failed
3 LANHO critical error
4 TDM Prog. logic device failed
5 Every on-board DSP failed
6 Receive network processor failed
7 Transmit network processor failed
8 Memory read failed
9 Dual UART chip failed
10 LANHO receive parity error
11 LANHO FIFO overflow error
12 LAN Bus timeout
13 LANHO Xmit FIFO overflow
14 One or more on-board DSPs failed
YY Aux Data Description
15 Backplane clock failed
16 Loss of signal
Continued on next page
Table 8-89. ATM Board Error Query Test (#1259) — Continued
Error
Code
Tes t
Result Description / Recommendation
Continued on next page
To Next Page
Loading...
