Description of the Software Modules and Parameters
Parameter manual b maXX BM3000
Document no.: 5.12001.07
213
of 820
4
52.4 Mean Isq 1
Display of the determined torque-producing currents while the drive is being operated at
constant speed Speed_1.
52.5 Mean Isq 2
Display of the determined torque-producing currents while the drive is being operated at
constant speed Speed_2.
52.6 Ks result acceleration
Display of the Ks results determined during an acceleration procedure. A negative value
means that the measurement was unsuccessful.
Interim result to evaluate the parameter Z52.8–.
52.7 Ks result deceleration
Display of the Ks results determined during a braking procedure. A negative value means
that the measurement was unsuccessful.
Interim result to evaluate the parameter Z52.8–.
52.8 Ks measured
Display of the Ks value determined.
If Ks was evaluated by the accelerating/braking method the value is shown in >52.8<
from the parameters
Z52.6– and Z52.7– by averaging. Both values should not differ too
much (+/-10%). A negative value means that the measurement was not successful.
52.9 Load friction factor
The determined coefficient of sliding friction, b, is displayed here in units of [(A/degree)/s].
52.10 Load friction
The determined static friction, c, is displayed here in units of [A]. The static friction will
have a different sign for different directions of revolution.