Description of the Software Modules and Parameters
Parameter manual b maXX BM3000
Document no.: 5.12001.07
357
of 820
4
108.11 Parameter selection status bit 15
Selection of the parameter for the freely definable Status Bit 15 in the drive manager Sta-
tus Word Z108.3–.
If at least one bit from the mask Z108.12– is set in the selected parameter, Bit 15 in the
Status Word will be set.
When StatusB15_IdSelect = 0, the mapping for Bit 15 is switched off.
108.12 Bit pattern status bit 15
Mask for the freely definable Status Bit 15 in the drive manager Status Word Z108.3–.
If at least one bit from the mask is set in the selected parameter Z108.11–, Bit 15 in the
Status Word will be set.
108.13 QUICK STOP reaction code
See also ZDrive management– from page 330
This parameter defines the response of the drive to a Quick Stop request (by control word
command or hardware control input).
For correct functioning of the braking procedures on the Quick Stop or Ramp-down
ramps, the speed controller must be adequately configured.
Value Meaning
0 Inhibit drive immediately
1 Return to ramp-down ramp
2 Return to Quick Stop ramp
3 Return to current limit
4 Return to voltage limit (acts like current limit)
5 Return to ramp-down ramp and remain in Quick Stop active mode (renewed
enabling possible)
6 Return to Quick Stop ramp and remain in Quick Stop active mode (renewed
enabling possible)
7 Return to current limit and remain in Quick Stop active mode (renewed
enabling possible)
8 Return to voltage limit and remain in Quick Stop active mode (renewed
enabling possible)
To Next Page
Loading...
Need help?
General