BONFIGLIOLI Agile User Manual

Error protocol
Problem
Cause
Possible remedy
Overvoltage
High load torques in the
case of field-orientated
control (DMC)
High load torques may cause error messages due to
overvoltage.
For an asynchronous motor, switch to sensor-less
control according to V/f characteristic (set P30 to
110).
Noise from drive
Motor noise or switching
noise in frequency in-
verter
Reduce switching frequency (P400).
Install input filter.
Install output filter.
Connect motor and frequency inverter to PE poten-
tial.
Install mains and motor cables separately from the
control cables.
Avoid motor vibration.
Output frequency is
resonant frequency of
system
Set blocking frequencies (P447, P448) and hysteresis
(P449) to disable output frequency ranges.
PID controller
output signal
defective
Parameter setting
Set P475 or P492 to "30 - Technology controller".
Set P476 or P494 to the source for the reference
value.
Set P478 to the source for the actual value.
Start signal (P68 or P69) starts the PID controller.
Connection
Check connection for actual value signal.
Digital inputs
have 0 V instead
of a voltage of
approx. 20 V
Energy saving function
Caused by functionality (see chapter 8.3).
If undesired: Deactivate Energy saving function
(P1511) or select an operation mode, that doesn’t
switch off the I/O’s.
334
Operating Instructions
Agile 06/2013 Troubleshooting

BONFIGLIOLI Agile Specifications

General

Brand	BONFIGLIOLI
Model	Agile
Category	DC Drives
Language	English