98 100-412-234 REV. 06
• Do not operate the power supply with the cover removed
• To prevent the possibility of electric shock, always plug the 2000Xc Power Supply into a grounded
power source
• Keep hands out from under the horn. Down-force (pressure) and ultrasonic vibrations can cause
injury
• Large plastic parts can vibrate within the audible frequency range when welded. If this occurs,
use hearing protectors to prevent possible injury
• Do not press the Test switch or cycle the welding system if either the RF cable or the converter is
disconnected. High voltage could be present at open power connections
• When using horns, avoid situations in which fingers could be pinched between the horn and the
fixture
• Assure power switch is in the OFF position before making or breaking any electrical or pneumatic
connections to the power supply, actuator or welder
• Do not touch Ultrasonic Horn during or immediately following the welding cycle. Vibrations and
heat can burn skin
DANGER
High voltage is present in the 2000Xc Power Supply. When setting up
and operating the welding system, observe the potential hazards
listed below.
CAUTION
Do not allow a vibrating horn to touch a metal base or metal fixture.
NOTICE
The power supply MUST be set to the correct cylinder size for the
actuator to function properly.
The regulator will click as it is regulating or maintaining a pressure
setting. If there is excessive noise, the supply pressure to the
regulator maybe too low for the requested setting.
To Next Page
Loading...
