Branson 2000Xc - Figure 6.48 Cold Start; Figure 6.49 Actuator Cold Start

160 100-412-234 REV. 06
Figure 6.48 Cold Start
6.14.4 Actuator Cold Start
Press the Actuator Cold Start button to open the actuator cold start screen.
A cold start clears the Spring Rate Table values stored in BBR, and restores them to
original factory defaults. It is not necessary to perform an Actuator Cold Start during
normal operation and servicing, but you might find a cold start helpful when you are
unable to make the system calibrate properly.
Figure 6.49 Actuator Cold Start
NOTICE
Using the Act Cold Start procedures will return the Spring Rate
settings to factory default.