100-412-234 REV. 06 159
6.14.1 Digital Tune
Press the Digital Tune button to toggle between On and Default. This must be set to On in
order to set the start frequency.
6.14.2 Start Frequency
Press the Start Freq button to set the start frequency.
6.14.3 Cold Start
Press the Cold Start button to open the Cold Start screen.
A cold start clears the Weld Setup Menu values and restores them to original factory
defaults. It is not necessary to perform a cold start during normal operation and servicing,
but you might find a cold start helpful when:
• You suspect the system is not operating properly
• You want to make a new setup
NOTICE
Do not use this feature unless advised to do so by Branson. It is not
required for most applications.
NOTICE
A cold start may take between 6 seconds and 1 minute depending on
when it is done and what actuator and control level is connected.
NOTICE
Using the Cold Start procedures will erase your current setup and
some of the Setup parameters in the System Configuration menu. Be
sure you have a record of your setup if you want to retain it. Your
settings can be saved to a preset.
To Next Page
Loading...
