100-412-234 REV. 06 39
3.2 Receiving
Branson actuator and power supply units are carefully checked and packed before
dispatch. It is recommended, however, that you follow the procedure below upon
receiving your Welding System.
Inspect the equipment when it is delivered:
Table 3.2 Receiving
Step: Action:
1
Check the equipment immediately after delivery to ensure that they have
not been damaged during transport.
2 Verify that all parts are complete according to the delivery note.
3
Determine if any component has become loose during shipping and, if
necessary, tighten screws.
NOTICE
If the goods delivered have been damaged during shipping, please
contact the forwarding agent immediately. Retain packing material
(for possible inspection or for sending back the unit).
CAUTION
The actuator and the power supply are heavy. Handling, unpacking,
and installation may require the assistance of a colleague or the use
of lifting platforms or hoists.
To Next Page
Loading...
