Branson 2000Xc - System Configuration; Figure 6.27 Operator Authority; Figure 6.40 Component Verify; Table 6.13 System Configuration

100-412-234 REV. 06 131
6.10 System Configuration
The following parameters are available in System configuration:
Table 6.13 System Configuration, Page 1
System Configuration, Page 01
Units Start Screen
User ID Setup USB Data
Operator Authority Cycle Counter
Basic/Expert Time
Table 6.14 System Configuration, Page 2
System Configuration, Page 02
Date Part-ID Scan
Preset Barcode Start Extra Cooling
Ext Presets Windows Setup
Horn Clamp User I/O
Table 6.15 System Configuration, Page 3
System Configuration, Page 03
Bargraph Scales Column Setup
Screen Setup Beepers
Automation Authority Check
Act Settings Weld History Setup
Table 6.16 System Configuration, Page 4
System Configuration, Page 04
Sys Components Component Verify
Freq Offset Memory Full
Digital Filter Welder Addr
Reset Required Amp Control
Table 6.17 System Configuration, Page 5
System Configuration, Page 05
Downspeed Tuning Key
RS232 Pressure Step Down
WebSrv Automation WebSrv AuthCheck