148 100-412-234 REV. 06
6.10.29 Digital Filter
Set the digital filter for graphing on or off.
6.10.30 Welder Addr
Turn on to assign a unique trackable number to a welder for data collection. This
information will be displayed in System Information.
6.10.31 Reset Required
If Reset Required is set to On, the Reset key needs to be pressed before welding another
part.
6.10.32 Amp Control
Press the Amp Control button to set the amplitude control to internal or external.
6.10.33 Downspeed Tuning
If the Downspeed Tuning function is set to on in the System Configuration screen, the flow
valve can be fine tuned to the actuator speed required.
6.10.34 Key
Reserved for special product configuration codes.
NOTICE
Branson recommends that you set the Digital Filter to on.
To Next Page
Loading...
