Branson 2000Xc - Events; Table C.1 Event Records; C.1 Events

262 100-412-234 REV. 06
C.1 Events
The following table details the Events you can encounter on the 2000Xc Power Supply.
Table C.1 Event Records
Event
ID
Name Description
Reason
Required?
EV100
Parameter Changed on a
Validated Preset
Any change in any parameter on a
validated preset will reset the
preset's validated bit and create an
event record. The parameter
changed will be in current preset
only and will not affect the saved
preset until saved by the user.
Operator will not be allowed to
change any parameter in a
validated preset.
Yes
EV101 Preset Validation Bit is Set
This event is created every time
the value of the preset validation
bit is set manually from the Save/
Recall Preset screen by the user.
Yes
EV102 New User Created
This event will be created when an
Executive level user is creating a
new User ID.
Yes
EV103 User Modified
This event is created if the user
changes the below parameters
related to the User ID from menu
or web service.
User level
Status
Password
Operator Authority
Yes
EV104 Date Or Time Changed
This event is created when the user
modifies the date or time of the
system from menu.
Yes
EV105 Factory Automation Mode
This event is created when the user
toggles the factory automation
status from menu.
Yes
EV106
H/W Assembly Number
Change
This event is created when any of
the assembly number is changed
from menu.
Yes
EV107 H/W Verify Setup Change
This event is created when
component verify setup is changed
from menu.
Yes
EV108 Software Version Change
This event is created at power up
when software version of the code
is found different from that in
previous power up.
No