100-412-234 REV. 06 263
EV109 Authority Check Changed
This event is created when the user
toggles the authority check from
the menu.
Yes
EV110 Actuator Cold Start
This event is created after an
actuator cold start is done from the
Diagnostic menu.
Yes
EV111 RTC Low Battery Failure
This event is created at power up if
the battery providing power to RTC,
when 24 volt is not present, is
found to be low below a threshold.
NOTICE
The date or time of the system
should be set from system
Configuration menu at least once.
Otherwise this event will occur at
every power up independent of
battery status.
No
EV112 Calibration Completed
This event is created after Pressure
or Force calibration from menu is
passed or failed.
Yes
EV113
Preset Validation Bit is
Cleared
This event is created every time a
validation bit is cleared.
Yes
EV117 Power On CRC Changed
This event is created at power up
when code CRC is found different
from that in previous power up.
No
EV118 Clock Lost
This event is created when
unexpected loss of lock condition
occurs for CPU clock.
No
EV202 Parameter Changed
Non-validated preset parameter
changed.
No
EV303 Horn Scan Completed
This event is created after Horn
Scan is completed successfully.
No
EV416 Program Firmware
This event is created after a new
firmware is successfully uploaded
to the system from Ethernet
interface.
No
EV501 User Login User successfully logs in. No
EV502 User Logout User logs out. No
Table C.1 Event Records (Continued)
Event
ID
Name Description
Reason
Required?
To Next Page
Loading...
