Brother MFC-9010CN - Page 102

3-10
Confidential
* (X) at the end of the message shows the color of the toner cartridge or drum unit.
(X) must be either K (Black), Y (Yellow), M (Magenta) or C (Cyan).
Error message
Description/Measure
Refer to:
Replace PF Kit1
It is time to replace the paper feeding kit. Replace the
paper feeding kit.
3-24
Scan Unable XX
The machine has a mechanical problem. 3-43
I
3-45
Short paper
Open the back cover (back-output tray) to let the printed
paper out on the back-output tray and then press Start/
Black button.
3-27
Size Mismatch
Put the same size paper in the paper tray or manual feed
slot that is selected in the machine driver, and then press
Start/Black button or select the size of paper which you
set in the paper tray size setting from the control panel
cover ASSY.
3-35
3-39
Small paper
Open the back cover (back-output tray) to let the printed
paper out on the back-output tray and then press Start/
Black button.
3-27
Toner Error
Dismount the drum unit of the color displayed on the LCD
or all the drum units, and then take out the toner cartridge
from the drum unit(s). Put the toner cartridge back to the
drum unit(s), and remount the drum unit(s) to the printer.
3-47
Toner Low (X) * The toner cartridge is nearly empty. Buy a new toner
cartridge that is indicated on the LCD before you get a
“Replace Toner” message.
3-30
Too Many Files
(USB direct interface
model only)
There are too many files stored on the USB flash
memory drive.
---
Unusable Device
(USB direct interface
model only)
Remove the USB flash memory drive from the USB
Direct Interface.
3-48
3-56
WT Box End Soon
The waste toner box will need replacement soon. Buy a
new waste toner box before you get a “Replace WT Box”
message.
3-28
3-53