32
Compulite
Chapter 2
4 Press ENTER or STORE.
5 Press
RESET to exit the DMX port display.
OR
1 Press
CHANNEL and 5 to select the channel.
2 Press
DIM.
3 Press
1 (the port) / (slash) 50 (dimmer) or use the direct dimmer number, in this example,
50.
4 Press
ENTER or STORE.
5 Press
RESET to exit the DMX port display.
OR
1 Press
CHANNEL and 5 to select the channel.
2 Press
DIM.
The touch screen is in
DMX Address mode.
3 Page until dimmer 50 is visible and tap dimmer 50 to select.
4 Tap
SET.
The new DMX offset for channel 5 is stored.
5 Press
RESET to exit the DMX port display.
To patch viewing the fixture grid
1 Press
SETUP.
2 Tap
PATCH BY FIXTURE.
3 Select the fixture.
4 Press
DIM.
5 Select a DMX address.
6 Press
ENTER or tap SET.
To patch a range of fixtures
Example: Patch channels 1 through 10 to dimmers 51 through 60.
1 Select channels 1 through 10.
2 Press
DIM.
The touch screen is in
DMX Address mode.
3 Select DMX 51 either on the keypad or on the touch screen.
4 Press
ENTER or STORE or tap SET.
Channel 1 is patched to DMX 51, channel 2, to DMX 52, channel 3 to DMX 53, etc.
5 Press
RESET to exit the DMX port display.
To Next Page
Loading...