24 • DM NAX® Product Manual — Doc. 9045M
❼
SETUP: (1) Push button: Pressing and holding the SETUP button for 15 seconds with
power supplied clears network settings and restores the default DHCP mode;
Pressing and holding the SETUP button with power disconnected, then connecting
the power supply and continuing to hold SETUP button for 30 seconds performs a
factory restore;
(1) LED, illuminates red when the button is pressed, flashes red when reset has been
initiated
❽
CONSOLE: (1) Standard USB 2.0 Type B connector, female
❾
POWER OUTLET: (1) 100-240V~50/60Hz Universal AC; IEC 60320 C14 Main power
inlet, mates with removable power cord (included)
❿
GROUND: 6-32 screw, chassis ground lug
To Next Page
Loading...
Need help?
General
