Product Manual — Doc. 9045M DM NAX® • 318
Save Changes
Click Save Changes to save any changes made to the configuration settings.
Revert
Click Revert to revert the device back to the last saved configuration settings.
Reboot the DM-NAX-4ZSP
Certain changes to the settings may require the DM-NAX-4ZSP to be rebooted to take effect. To reboot
the device, do the following:
1. Click Reboot in the Actions drop-down menu. The Confirmation message box appears.
2. Click Yes, Reboot Now to reboot the device. The Reboot message box appears.
Wait for the device reboot to complete before attempting to reconnect to the device.
Restore to Factory Default Settings
1. Click Restore in the Actions drop-down menu to restore the settings of the DM-NAX-4ZSP to
factory defaults.
NOTE: When settings are restored, all settings, including the network settings, will revert to
the factory default. If a static IP address is set, restoring the device to factory default
settings will revert the IP address to the default DHCP mode.
2. Click Yes in the Confirmation dialog to restore the DM-NAX-4ZSP to factory settings. Click No to
cancel the restore operation.
A dialog is displayed again, indicating that the restore process was successful and that the device
rebooted.