Crestron DM NAX Series - DM-NAX-AUD-USB Specifications

58 • DM NAX® Product Manual — Doc. 9045M
DM-NAX-AUD-USB Specifications
Product specifications for the DM-NAX-AUD-USB are provided below.
Specifications
Audio
Input Signal Types USB stereo;
Unbalanced stereo analog line-level;
DMNAX/AES67 audio-over-IP
Output Signal Types USB stereo;
Unbalanced stereo analog line-level;
DMNAX/AES67 audio-over-IP
Source Compensation ±10.0dB per input
Input Monitoring Source Signal Detect
Frequency Response (at
line-level output)
20Hz to 20kHz ±0.5dB
THD+N (at line-level
output)
0.005% @ 1kHz, max output
S/N Ratio (at line-level
output)
From line-level input: 108dB, 20Hz to 20kHz, A-weighted;
From digital input: 111dB, 20Hz to 20kHz, A-weighted
Balance Control Left/right adjustable
EQ Filter Types EQ, High Pass, Low Pass, Treble Shelf, Bass Shelf, Notch
EQ Center Frequency 10 to 20,000Hz per band
EQ Gain +20/-40dB per band
EQ Bandwidth 0.1 to 4.0octaves per band
Communications
Ethernet For control and PoE, AoIP, and/or console, 100/1000 Mbps, auto-switching, auto-
negotiating, auto-discovery, full/half duplex, DHCP
USB Bidirectional USB Audio Class 1 (UAC1) device connection, up to 24-bit/48kHz stereo
audio transfer
Connectors
USB (1) USB Type-C connector, female;
UAC1 audio support;
Enumerates as a Non-AEC Enabled Speakerphone
INPUT (1) 1/8in. 3.5mm connector, female TRS;
Unbalanced line-level audio input;
Maximum input level: 2Vrms;
Input Impedance: 10kΩ