Crestron DM NAX Series User Manual

Product Manual — Doc. 9045M DM NAX® • 444
l
Application Mode:The Application Mode determines which options and controls are available.
o
Select Residential (Standard) or Commercial (Advanced). A Reboot confirmation message
box appears.
o
Click Yes, Reboot Now to reboot the device into the selected mode. The Reboot message
box appears.
o
Wait for the device reboot to complete before attempting to reconnect to the device.
l
Standby Mode:Select the DM-NAX-AMP-X300's standby behavior.
o
Always On: The device's amplifier remains powered on at all times.
o
Power Saver: If no signal is detected for 25 minutes, the device enters a low power state by
turning off the amplifier board. Upon detecting an audio signal, the amplifier will be turned
back on.
Commissioning
The Commissioning section provides a quick way to automatically assign multicast addresses to all of
the device's internal audio-over-IP stream transmitters.
Click Assign Addresses to give each DM NAX transmitter in the DM-NAX-AMP-X300 a unique multicast
address beginning with the specified Starting Multicast Address. The valid range for Starting Multicast
Address is 239.8.0.0 to 239.127.255.255.

Crestron DM NAX Series Specifications

General

Brand	Crestron
Model	DM NAX Series
Category	Conference System
Language	English