Crestron DM NAX Series - DM-NAX-4 ZSA-50 Specifications

40 • DM NAX® Product Manual — Doc. 9045M
DM-NAX-4ZSA-50 Specifications
Product specifications for the DM-NAX-4ZSA-50 are provided below.
Specifications
Audio
Input Signal Types 2 stereo analog (RCA);
2 digital S/PDIF (1 TOSLINK®connection and 1 coaxial connection, PCM only)
Output Signal Types 4 stereo speaker-level amplified outputs;
1 stereo analog line-level output
Sampling Rates and Bit
Depths
Digital Input (Coaxial): Up to 192kHz, 24-bit;
Digital Input (Optical): Up to 192kHz, 24-bit;
Media Players:Up to 192kHz, 24-bit
Source Compensation ±10.0dB per input
Input Monitoring Source Signal Detect
Output Power 50W per channel at 4 or 8Ohms
Amplifier Monitoring Over Current, Over/Under Voltage, Over Temperature, DC Offset, Clipping
Frequency Response 20Hz to 20kHz ±0.5dB
THD 0.006%
S/N Ratio 110dB digital in;
108dB analog in
Stereo Separation 95dB @ 1kHz, 8Ohm;
90dB @ 1kHz, 4Ohm
Zone Separation 100dB @ 1kHz, 8Ohm;
95dB @ 1kHz, 4Ohm
Zone Volume Level Control -80.0 to +20.0dB, adjustable from 0% to 100% plus mute
Bass Control ±12.0dB
Treble Control ±12.0dB
Loudness Compensation On/Off
Dynamic Range Control Off/Low/Medium/High
Balance Control Left/right adjustable
Zone Configuration Stereo Single Ended;
Mono Single Ended
Power Limiting Configurable 5 to 50W @ 4 or 8Ohms
Tone Profiles Flat, Classical, Jazz, Pop, Rock, Spoken Word
EQ Filter Types EQ, High Pass, Low Pass, Treble Shelf, Bass Shelf, Notch
EQ Center Frequency 10Hz to 20kHz per band
EQ Gain -40.0to +20.0dB per band
EQ Bandwidth 0.1 to 4.0octaves per band
Bus Volume Offset ±12.0dB per zone for output bussing