Crestron DM NAX Series User Manual

Product Manual — Doc. 9045M DM NAX® • 41
Communications
Ethernet For control, AoIP, and/or console;
100/1000Mbps, auto-switching, auto-negotiating, auto-discovery, full/half duplex,
DHCP
Connectors
SPEAKERZONES 1-4 (4) 4-pin 5.08mm detachable terminal blocks;
Stereo speaker-level audio outputs;
Maximum Wire Size: 12AWG
LINEOUT 5 (2) RCA female comprising (1) unbalanced stereo line-level audio output;
Output Impedance: 100Ohms;
Maximum Output Level: 2Vrms
DIGITALINPUT1 (1) RCA female;
S/PDIF coaxial digital audio input;
Input Impedance: 75Ohms
DIGITALINPUT2 (1) JIS F05 female TOSLINK® optical fiber connector;
S/PDIF optical digital audio input
ANALOGINPUTS 3-4 (4) RCA female comprising (2) unbalanced stereo line-level audio inputs;
Input Impedance: 10kOhms;
Maximum Input Level: 2Vrms
ETHERNET1-2 (2) 8-pin RJ-45 connectors, female;
100BASE-TX/1000BASE-T Ethernet port;
Green LED indicates Ethernet link status;
Flashing amber LED indicates Ethernet activity
100-240 VAC 1.0-0.4A
50/60HZ
(1) 100-240V~50/60Hz Universal AC; IEC 60320 C14 main power inlet, mates with
removable power cord (included)
Controls and Indicators
PWR (1) LED;
Amber indicates that the device is booting;
White indicates that the device is switched on with audio passing;
Red indicates that the device is in standby mode
LAN (1) White LED;
Indicates that the device has a valid IP address
NAX (1) White LED;
White indicates that audio-over-IP traffic is passing in or out of the DMNAX unit
SOURCE 1-4 (4) LEDs;
White indicates signal presence on the specified input/source;
Red indicates there is clipping on the specified input/source
ZONE1-5 (5) LEDs;
White indicates there is audio output on the indicated zone;
Red indicates a fault due to clipping, over current, over temperature, or low voltage

Crestron DM NAX Series Specifications

General

Brand	Crestron
Model	DM NAX Series
Category	Conference System
Language	English