EasyManuals Logo

Crestron DM NAX Series User Manual

Crestron DM NAX Series
649 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #279 background imageLoading...
Page #279 background image
Product Manual Doc. 9045M DM NAX® 272
Control System
1. Click the Encrypt Connection button to navigate to the Security tab to configure encryption
settings.
2. Enter the username in the Control System Username field.
3. Enter the password in the Control System Password field.
4. Enter the Room ID in the Room ID field.
5. Enter the IP ID of the DM-NAX-4ZSA-50 in the IP ID field.
6. Enter the IP address or hostname of the control system in the IP Address/Hostname field.
7. Click the Save Changes button to save the new entries. The Control System Save message box
appears, indicating that the control system settings were saved successfully. Click the Revert
button to revert to the previous settings without saving.
Commissioning
The Commissioning section provides a quick way to automatically assign multicast addresses to all of
the device's internal audio-over-IP stream transmitters.
Click Assign Addresses to give each DM NAX transmitter in the DM-NAX-4ZSA-50 a unique multicast
address beginning with the specified Starting Multicast Address. The valid range for Starting Multicast
Address is 239.8.0.0 to 239.255.255.247.
NOTE: This will begin transmitting multicast traffic on your network, refer to the DM NAX Audio-
over-IP System Design Guide document for details.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Crestron DM NAX Series and is the answer not in the manual?

Crestron DM NAX Series Specifications

General IconGeneral
BrandCrestron
ModelDM NAX Series
CategoryConference System
LanguageEnglish

Related product manuals