Product Manual — Doc. 9045M DM NAX® • 135
Front Panel
Connect an unbalanced line-level audio input to the INPUT TRS port.
Connect an unbalanced line-level audio output to the OUTPUT TRS port.
Reset the Device
A network reset or factory restore may be performed when troubleshooting.
CAUTION: These procedures should only be performed as a last resort to recover an unresponsive
device. Both the Network Reset and Factory Restore procedure will clear certain device settings that
cannot be recovered once the procedure is complete. Before performing these procedures, please
contact Crestron True Blue Support via phone, email or chat as described at
www.crestron.com/support.
Network Reset
1. Ensure the device is powered on.
2. Press and hold the SETUP button for up to 15 seconds until the SETUP LEDflashes red.
The device will reboot, and the default network settings will be reset. The device will be reverted to its
default hostname, with DHCP enabled, and no static IP set.
Factory Restore
1. Turn off the device by disconnecting the power cable from the device.
2. Press and hold the SETUP button and then reconnect the power cable while still holding the
SETUP button. Continue holding the SETUP button for up to 30 seconds until the SETUP LED
flashes.
The device will reboot, and all the factory default settings will be restored, such as audio settings,
multicast addressing, etc.
CAUTION: Performing a factory restore will clear all settings from the device configuration.
To Next Page
Loading...
Need help?
General
