Product Manual — Doc. 9045M DM NAX® • 89
The device will reboot, and the default network settings will be reset. The device will be reverted to its
default hostname, with DHCP enabled, and no static IP set.
Factory Restore
1. Turn off the device by disconnecting the power cable from the device.
2. Press and hold the SETUP button and then reconnect the power cable while still holding the
SETUP button. Continue holding the SETUP button for up to 30 seconds until the SETUP LED
flashes.
The device will reboot, and all the factory default settings will be restored, such as Zone settings,
streaming service accounts, multicast addressing, etc.
CAUTION: Performing a factory restore will clear all settings from the device configuration.
To Next Page
Loading...
Need help?
General
