Product Manual — Doc. 9045M DM NAX® • 15
DM-NAX-16AIN
The Crestron DM NAX® Audio-over-IP (AoIP) encoder (DM-NAX-16AIN) provides 16 local stereo audio
inputs to a DM NAX Crestron multiroom audio distribution network. It provides 8 digital inputs
comprised of 4 SPDIF TOSLINK® connectors and 4 SPDIF coaxial connectors. Each digital input supports
2-channel PCM audio. The DM-NAX-16AIN also provides 8 analog stereo inputs. Inputs 1-4 offer
balanced 5-pin terminal block connectors in parallel with unbalanced RCA connectors, and inputs 5-8
offer RCA connectors.
For installation information, refer to the DM-NAX-16AIN Quick Start.
Physical Description
The following sections provide information about the connectors, controls, and indicators that are
available on the DM-NAX-16AIN device.
Front Panel
The following illustration shows the front panel of the DM-NAX-16AIN.
❶
PWR: (1) LED, indicates operating power is supplied; illuminates amber while
booting, white when powered on, red when in standby (no audio or LAN
connection), and off when no power is supplied.
❷
LAN: (1) LED, illuminates white when the device is connected to a network with
a valid IP address, and off when the device is not connected to a network or the
IP address is invalid.
❸
NAX: (1) LED, illuminates white when the AoIP is ready to pass and the unit's
PTP clock is synced, and off when there is no AoIP is passing to or from the
device and/or PTP is not synced.
❹
ANALOG SOURCE: (8) LEDs, illuminates white when a signal is detected on the
specified input/source, red when there is clipping on an analog input and off
when there is no signal detected on the specified input/source.
❺
DIGITAL SOURCE: (8) LEDs, illuminates white when a signal is detected on the
specified input/source, red when there is bitstream audio detected on a digital
input, and off when there is no signal detected on the specified input/source.
To Next Page
Loading...
Need help?
General
