Crestron DM NAX Series - Bluetooth Settings; Main Bluetooth Settings

Product Manual — Doc. 9045M DM NAX® • 600
Bluetooth Settings
The Bluetooth section provides settings for the internal Bluetooth radio of the DM-NAX-BTIO-1G. These
settings are divided up into two tabs, labeled Main and Advanced.
Main Bluetooth Settings
To configure the settings on the Main tab of the Bluetooth settings section:
l
Enter a custom name for the DM-NAX-BTIO-1G in the Bluetooth Name text field. This is the name
that will be displayed on source devices (such as smartphones)that discover the
DM-NAX-BTIO-1G as a casting destination.
l
Set the Bluetooth Enable toggle to the right to allow Bluetooth wireless audio casting to the
DM-NAX-BTIO-1G. Set the Bluetooth Enable toggle to the left to disable Bluetooth wireless audio.
NOTE: While Bluetooth audio is disabled on the device, some applications that scan for
Bluetooth devices may still be able to detect the DM-NAX-BTIO-1G. These applications will
not be able to connect to the DM-NAX-BTIO-1G or cast audio to it while Bluetooth audio is
disabled.
l
Set the Pairing Active toggle to the right to enable pairing mode, allowing Bluetooth devices to
pair to the DM-NAX-BTIO-1G. Set the Pairing Active toggle to the left to disable pairing mode.
l
The Paired Devices table displays the name and status of all remembered Bluetooth devices that
were previously paired with the DM-NAX-BTIO-1G.
o
The DM-NAX-BTIO-1G can remember up to seven previously paired devices.
o
Only one paired Bluetooth device can have a Connected status at a time. All other paired
devices will display a Disconnected status. The Connected status indicates which device is
currently able to actively cast media to the wall plate.
o
To disconnect a connected device, click the button.
o
To forget a remembered device from the Paired Devices table, click the button.