Crestron DM NAX Series - Adapter 1

421 • DM NAX® Product Manual — Doc. 9045M
NOTE: By default, the hostname of the DM-NAX-AMP-X300 consists of the model name followed
by the MAC address of the device. For example, DM-NAX-AMP-X300-00107FB58088.
Adapter 1
The Adapter 1 subheading contains settings for DHCP, IP Address, Subnet Mask, and Default Gateway
of Ethernet adapter 1 on the rear panel of the device.
NOTES:
l
An + Adapter 2 option only appears when the dual Ethernet ports on the DM-NAX-8ZSA are
set to isolate traffic using the Port Selection feature. The settings for Adapter 2 are identical
to those available for Adapter 1.
l
DMNAX devices' internal processes use IP addresses in the 10.10.10. xxx range. This IP range
should be avoided when addressing DMNAX devices to prevent conflicts with these internal
addresses.
Set the DHCP toggle to enabled (right) or disabled (left) to specify whether the IP address of the
DM-NAX-AMP-X300 is to be assigned by a DHCP (Dynamic Host Configuration Protocol) server.
l
Enabled: When DHCP is enabled (default setting), the IP address of the DM-NAX-AMP-X300 is
automatically assigned by a DHCP server on the local area network (LAN).
l
Disabled:When DHCP is disabled, manually enter information in the following fields:
o
Primary Static DNS: Enter a primary DNS IP address.
o
Secondary Static DNS: Enter a secondary DNSIPaddress.
o
IP Address: Enter a unique IP address for the DM-NAX-8ZSA.
o
Subnet Mask: Enter the subnet mask that is set on the network.
o
Default Gateway: Enter the IP address that is to be used as the network’s gateway.
To save any new network entries, click Save Changes.