To Next Page

To Previous Page

223 • DM NAX® Product Manual — Doc. 9045M

Casting

The Casting section is used to enable or disable the ability of third-party devices to cast audio to the

DMNAX output zone, as well as set a maximum casting volume and friendly name for the zone.

To configure Casting:

1. Maximum Casting Volume is an alternate value for the Maximum volume set in the

Minimum/Maximum Volume on page 214 settings, applied to the zone only when a casting service

is routed to it. To set the maximum casting volume, do one of the following:

Move the Maximum Casting Volume slider right to increase or left to decrease the

maximum volume.

Click the arrows to increase or decrease the maximum casting volume. Values range from

70% to 100%, adjustable in increments of 1%.

Manually enter a value in the Maximum Casting Volume field.

NOTE:If the Maximum Casting Volume value is higher than the regular Maximum volume

value, the Maximum value will be applied instead.

2. A custom casting name (for example, "Living Room") must be entered so that a name for the

zone will be displayed in the list of available casting destinations when initiating a stream. Enter

this friendly name in the Casting Name field.

NOTE:Ensure that the Casting Name field is populated as any field with an asterisk (*) is

mandatory.

Once AirPlay® and/or Spotify Connect™ are enabled, this name will be displayed as an available

destination on the casting device.

Crestron DM NAX Series User Manual

Questions and Answers: