To Next Page

To Previous Page

Product Manual — Doc. 9045M DM NAX® • 31

Bluetooth® Wireless Connectivity

Bluetooth wireless audio support is built-in to the DM-NAX-BTIO-1G, allowing a stereo audio signal to be

transmitted from a smart phone or other source device to the wall plate. This stereo signal can be

output as a DMNAXAoIPstream onto the network or as an unbalanced line-level analog signal from

the local 3.5mm audio output connector. Metadata for the Bluetooth audio stream can be displayed on

the front panel, and up to seven previous source device connections can be recalled.

Audio-over-IP

DMNAX takes audio distribution to a whole new level by putting it on the network. The

DM-NAX-BTIO-1G sends and receives DMNAX and AES67 encoded audio over a standard IP network. A

single DMNAX system can handle audio distribution between 32 DMNAX devices and supports up to

256 audio output zones. DMNAX devices can seamlessly pull and distribute the audio from DMNVX

sources.

Encoder and Decoder Functionality

The DM-NAX-BTIO-1G can operate as a network AV encoder and decoder. The local input sources on the

wall plate can be sent as AoIP streams to DM NAX, Dante, or AES67 capable devices. Simultaneously,

the DM-NAX-BTIO-1G can receive AoIP streams from these same devices and decode them for local

output.

Front Panel Controls and Display

The DM-NAX-BTIO-1G features four front panel push buttons and a 128x64 dot matrix OLED display.

The push buttons allow local volume control and Bluetooth pairing, with volume feedback and pairing

status reflected in real time on the display. Metadata for Bluetooth media and basic configuration

menus are also shown on the display.

Both the display and push buttons can be disabled via the configuration web interface or programming

for applications where a more discreet or secure installation is required.

Crestron DM NAX Series User Manual

Questions and Answers: