Crestron DM NAX Series - Configure Transmitters

Product Manual — Doc. 9045M DM NAX® • 292
Configure Transmitters
NOTE: To configure transmitters not shown on the current page of the table, click the icon to
display the next page of transmitters.
To configure a DM NAX transmit stream, do the following.
1. Enter a valid multicast address in the NAX Stream Address field.
2. Enter a name in the NAX Stream Name field by which the stream can be identified. This stream
name is associated with the DMNAX stream's multicast address by other DMNAX or AES67
devices, like a device hostname that resolves to a given IPaddress.
3. Status indicates whether a stream is transmitting or not. When the stream has started or
stopped, the Status column will update accordingly.
4.
Click the configure button ( ) in the Actions column. The Configure dialog appears:
5. Set the Auto Initiation toggle to the right position to enable auto initiation. Set the toggle to the
left position to disable auto initiation.
l
If Auto Initiation is enabled for a given stream, the stream will begin transmitting
automatically and will be available as a multicast stream on your network at the specified
multicast address.
l
If Auto Initiation is disabled for the input, the stream will not begin transmitting until it is
manually initiated.