215 • DM NAX® Product Manual — Doc. 9045M
3. To set the default volume of the zone, do one of the following:
l
Move the Default slider to the right to increase or to the left to decrease the default
volume.
l
Click the % arrows to increase or decrease the default volume. Values range from 0 to 50%,
adjustable in increments of 1%.
l
Manually enter a value in the Default field.
NOTE: The Default volume is applied as the Zone volume any time the zone receives a source
route and no source was previously routed to that zone.
Stereo/Mono
1. Select either Stereo or Mono from the Stereo/Mono field.
2. Select the zone configuration from the Zone Configuration drop-down menu. The available values
are Standard, Bridged, Bridged 2.1, Bridged Sub 2.1, and Bridged Mono. See the diagrams below
for the output signal flow applied in each configuration.
NOTE: The Stereo/Mono field is disabled for the Bridged 2.1, Bridged Sub 2.1, and Bridged
Mono zone configurations.
Stereo - Standard
To Next Page
Loading...
Need help?
General
