11. Tech. Rep. Mode Field Service Ver. 1.0 Aug. 2005
156
bizhub 200/250/350
Adjustment / Setting
11.3.4 The amount of Center Erase
11.3.5 Orientation Change
11.3.6 Finisher
A. Punch Stop Position
B. Punch Loop Adjustment
11.3.7 Trail Erase (Dup)
Functions • To set the amount of center erase for bound originals.
Use • To change the amount of center erase for bound originals.
Setting/
Procedure
• The default setting is “12 mm”.
• The adjustment range is 2 to 20 mm.
Functions
• To set whether or not to match the orientation of the image when paper is fed out
between the normal mode and Staple and Punch mode.
Use
<ON>
• Turn ON the function if the orientation of the image when paper is fed out is matched
between the normal mode and Staple and Punch mode.
<OFF>
• Turn OFF the function if the orientation of the image when paper is fed out is not
matched between the normal mode and Staple and Punch mode.
Setting/
Procedure
• The default setting is “OFF”.
ON “OFF”
Functions • To adjust the paper stop position for punching.
Use • To adjust the punch position.
Setting/
Procedure
☞ For details on adjustment, see the Service Manual for Option FS-508.
Functions • To adjust the length of the loop for correcting skew during punching.
Use • To correct any skew in the punch position.
Setting/
Procedure
☞ For details on adjustment, see the Service Manual for Option FS-508.
Functions
• To set the adjustment value for the amount of erase on the trailing edge for 2-sided
printing.
Use
• The amount erased at the trailing edge of the second side of a 2-sided print is the Trail-
ing setting for Edge Erase + Duplex Trailing Erase setting.
Setting/
Procedure
• The default setting is “2 mm”.
• The adjustment range is 0 to 5 mm.
To Next Page
Loading...
