Develop ineo 350 - Page 202

Field Service Ver. 1.0 Aug. 2005 11. Tech. Rep. Mode
163
bizhub 200/250/350Adjustment / Setting
11.8.4 F7-2
11.8.5 F8
11.8.6 F12
11.8.7 Hard Disk Format
Functions • To automatically adjust the Original Size Detecting Sensor. (only for a FAX)
Use
• When the Original Size Detecting Sensor is replaced
• When an optional sensor is mounted
Setting/
Procedure
☞ For details on adjustment, see the Service Manual for Option FK-503.
Functions • To automatically adjust the ATDC sensor.
Use • When developer is replaced
Setting/
Procedure
1. From the Tech. Rep. Mode screen, touch [Function] → [F8] in that order.
2. Press the Start key to perform the ATDC sensor gain adjustment.
• After the adjustment is finished, the operation stops automatically.
• The adjusted setting overwrites the current setting for ATDC Sensor Gain in Printer of
Tech. Rep. Mode.
Functions
• To print on paper with the engine unit and check the printing and paper feeding in the
paper take-up/transport sections.
Use
Setting/
Procedure
1. From the Tech. Rep. Mode screen, touch [Function] → [F12] in that order.
2. Select the paper source, and then press the Start key.
Touch [Duplex] to feed out the paper along the paper path for 2-sided copying.
3. The sequence is halted when the Stop key is pressed or there is no paper.
Functions • To format the hard disk.
Use
• When a hard disk drive is installed.
• When the hard disk is initialized.
Setting/
Procedure
1. From the Tech. Rep. Mode screen, touch [Function] → [Hard Disk Format] in that
order.
2. Press the Start key to start the HDD formatting sequence.
NOTE
• NEVER turn OFF the power while the formatting sequence is in progress.
3. Turn OFF the Main Power Switch, wait for 10 sec. or more, and turn ON the Main
Power Switch again.